Illumination WALD STUDIO

31May/170

Tempo Lighting

Tempo is an industrial, architectural and theatre California based LED lighting company.  Their architectural line showcases mostly linear based products for interior and exterior spaces.   Most of the fixtures they offer can be made custom to accommodate different designs.   Tempo uses a 2-step MacAdam Elipse binning with 80+ CRI. All LEDs used are NICHE to maintain CCT throughout the products. Many of their modules can be replaced in the field with compression pins.

The C3S is a 3” low power, rigid and serpentine LED linear accent light.  It has a silicone track that can be flat or positioned with a stationary clip at a 10 or 20-degree angle.  This can be assembled both screwed or stapled to mount the fixture at any interval.  Because it is a module linear fixture the spacing between each LED board can be adjusted to fit what is needed per design.  RGB is tunable to 3 shades of white and dim effortlessly to 0 since the company is primarily theatre base.  $15-25 per ft.

The C4S is a 6” mid power, serpentine LED linear cove light.  It has a remote driver and a higher output compared to the C3S. The modules pivot at a +/- 90-degree angle.  $25-35 per ft.

C5R is a rigid linear, mid power, interior cove light.  Driver on board, it can have up a 790 line voltage and 60 x 115 wattage.  Track lengths range from 1’ increments up to 8’ per driver.

C6 High lumen, interior or exterior light.  The C6RX is IP66 rated.  It ranges from 2200-2700-3000-3500-4000K.  The design is more open to make the wire way more accessible.  The Modules can be made at a minimum of 1’ and maximum 6’ and has an anodized or painted finish. 

Prime FX is a asymmetric cove light.  It is designed to be mounted at the same height as the lip of the cove.  Recommended 4” away from the wall and 12-18” off the ceiling.  The fixture is 2.3”H x 1”D with a continuous run.  The telescoping spacers allow the wires to loop around itself and can be adjusted for custom lengths in the field.  They have new fabricated cove extrusions coming soon that are PVP type material and spackled. 

SPL is a step and path light.  CCT available, 2700- 4000K temperature options.  The exterior face finish can be made in black, white and espresso, with a black inner finish.  This can be surfaced as well. 

All fixtures have a 4-6 week lead time.

Comments (0) Trackbacks (0)

No comments yet.


Leave a comment

No trackbacks yet.

Follow on Feedly